It is a new analog-digital weight indicator with display. This indicator serves also for controling of simply weight aplications or filling weight systems. Connected through RS-485 interface with protokol Modbus RTU it can be used for distributed I/O systems.

DAT400	DAT500

Engineering characteristic:

• Dimensions: DAT400: 106x90x58 mm ( L x H x D). Mounting on DIN
                     DAT500: 96x48x120 mm ( L x H x D). Mounting on panel,  manhole: 92x44
• Material: ABS
• Protection DAT400(front): IP-20   DAT500(front): IP-51
• Weight: 230 g
• Working temperature: -10 až + 40^oC
• Power supply: 24 VDC ± 15%
• Power equirement: 5 W.
• Dislay and setting: 6x 7 segment LED digit, height 1,44 mm -- 4x red status LED --- 4x membrane buttons.
• Conversion response: 50 Hz (without filtration)
• Internal discernment: 60.000 poits
• Sensibility: 0,02 μ V/division
• Linearity: < 0,01% on the range
• Temperature effect: < 0,001% on the range/^oC
• Converter A/D: 24 bit
• Decimal point: 0,0 - 0,00 - 0,000 optional.
• For 6 load cells (350 Ohmů)  4 or 6 wire
• Output interface RS-232, RS 422 or RS 485.
• 2 digital (logical) input (opto-izolated, 24 VDC PNP - requierement external supply)
• 2 digital output (semiconductor relay, max. 24VDC/100 mA each)
• 1 analog output (0-10 VDC, max. resistance 10 kOhm or 4-20 mA , min. resistance 300 Ohm)
• Setting possible using buttons on front panel or through RS 232 interface and program INOVATION.
• Both direct or indirect calibration are possible (the second mentioned is suitable for calibration of  forces, big containers e.g. which cannot be calibrated directly).
• Power supply source for  DAT 400/500 Mod. 121 is recommended to be used

Power Supply Mod:121